The Model UV4-S is a 4-channel video splitter that can send a VGA or component video signal to multiple displays on CATx cable. This unit features a standard HD15 VGA connector for the input and has 4 RJ45 connectors for the outputs. It also provide an additional HD15 VGA connector for a local monitor.
The UV4-S can drive UTP cables of lengths up to 500 feet. At the remote (receiving) end of the cable, a model # UV1-R is required to convert the UTP cable signal back to video for connection to a monitor.
In most setups only one power supply is necessary for the entire system.
The UV4-S Sender/Splitter comes with a power supply that is capable of powering itself and all the UV1-R receivers.
For Cat5 runs of over 300 feet, the receivers may need their own additional supplies that must be ordered separately (HRT model # 511-PS9016A).
Made in the USA.
Support for local monitor at transmitter
Multiple Cat-5 outputs
Transmit video and phantom power on a single CATx cable
Eliminates the need for bulky, expensive and hard to build multi-coaxial cables for high-resolution video extension
Amplifies the signal for clean and crisp transmission
Differential signaling eliminates ground loops and noise
Handles resolutions up to 1920x1440 at 60Hz
Rugged, Reliable, Compact size
Single power supply fpr transmitter and all UV1-R receivers (under 300 ft)
Drive standard CATx cables to 500 feet for VGA and Component Video
VGA, SVGA, XGA, or UXGA video
VGA through UXGA, RGBS, RGsB (sync on green), or YpbPr
Up to 1920x1200 and 1080p at 500 ft
Video # and Type
1 analog signal input. Standard VGA output RGBHV, RGBS, RGsB, RsGsBs, component video (bi-/tri-level sync)
4 or 8 female RJ-45 output 1 HD15 video input 1 HD15 local video output
1 V p-p for Y of component video 0.7 V p-p for RGB and for Pr and Pb of component video 4.0 V to 5.0 V p-p, for TTL Sync signals of RGBHV, RGBS
Up to 500 ft. (150 m) for VGA and Component Video
Positive or Negative
100 VAC to 240 VAC, 50-60 Hz, external; 9 VDC regulated, Center Positive